Noshok 1800 Series Attachable Loop-Powered Indicator Manuale Utente Pagina 1

Operating Manual 1800 Series Attachable Loop-PoweredDigital Indicators1010 West Bagley Road, Berea, Ohio 44017 P 440.243.

Display Preferred state of the output Note off Inactive in case of an error on Active in case of an error - Press button 1 to validate the selecti

5.1 2-point-controller This chapter describes how to configure the switching points as use the device for a 2-point-controller. This instruction de

- Press button 1 to validate the delay time. The display shows “ A.dEL“ again. Example: You want to have a temperature alarm-monitoring of a greenho

- Press button 1 to validate your selection. The display shows “OFFS“ again. - When pressing button 1 again, the device will display “SCAL“ (scale

8 Error codes When detecting an operating state which is not permissible, the device will display an error code. The following error codes are defi

9 Specification Signal: 4 ... 20 mA (2-wire) / 0 ... 10V (3-wire) Voltage load: < 5.5 V Input resistance: ca. 30 kOhm Max. permissible in

CORPORATE HEADQUARTERS1010 West Bagley Road · Berea, Ohio 44017Ph 440-243-0888 · Fax 440.243.3472E-mail: [email protected]: www.noshok.com1

Index 1 INTRODUCTION 3 2 SAFETY REGULATIONS 3 3 ELECTRIC CONNECTION 4 3.1 ADJUSTMENT OF THE CONNECTIONS: 5 3.2 CONNECTIO

1 Introduction The indicator with LED-display is a microprocessor controlled displaying, monitoring and controlling device

Attention: When running electric devices, parts of them will always be electrically live. Unless the warnings are observed serious personal injuri

3.1 Adjustment of the connections The assignment of the angle-type plug is designed for the most commonly used assignments of the respective input

General instruction for change of the angle-type plug assignment: Remove the coupling insert by means of a screw driver at the position indicated (ar

Separate power supply for measurement section and output section 3.2.2 0 … 10 VDC: switching of a relay 4 Configuration: disp

4.1 Configuration of the input signal - Turn the device on and wait until it completed its built-in segment test. - Press button 2 for 1 second,

- Press button 1 to validate the selection, the display shows “ Li“ again. - When pressing button 1 again, the display will show “ FiLt“ (Filter).